Wednesday, March 10, 2010

Behold, failure!


Last Saturday, my friend Brad came over to help finish the brakes on El Shitbox. Since the caliper mounting bolt was seized in place, I asked him to bust out the Sawzall and cut the fucker in half.

Then, when the caliper still wouldn't come off, I realized the caliper mounts to a bracket, which is removable. Two 14-mm bolts later, and the caliper-and-bracket assembly is off.

But then the caliper wouldn't come off the bracket, which is necessary to mount the new caliper. So I asked Brad to bust out his MAPP gas torch. He's a plumber.


We proceeded to heat, wiggle, and hammer that thing to separate the caliper from the slide/guide bolt on the bracket. At which point, this happened:



Which is about when I realized I had a complete new bracket sitting upstairs. So I grabbed that, grabbed the new caliper, and put that shit together.

Steps necessary to complete job:
1. Remove caliper and bracket assembly.
2. Install new caliper bracket.
3. Install new caliper.

Actual steps taken:
1. Cut caliper.
2. Remove caliper and bracket assembly.
3. Lubricate, wiggle, torch, and hammer caliper guide bolt until something breaks.
4. Install new caliper bracket.
5. Install new caliper.

I am a genius.

1 comment:

  1. However, your genius is overshadowed by your dapper good looks and fantastic vocabulary! - Duncan

    ReplyDelete

Note: Only a member of this blog may post a comment.